Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 615

ppp reassembly
pppoe acName
pppoe always-offer
Copyright © 2010, Juniper Networks, Inc.
Use to resolve conflicts when the router and the PPP peer system have the primary
and secondary DNS and WINS addresses configured with different values.
By default, the DNS and WINS addresses configured on the router take precedence.
Use the ppp peer dns command or the ppp peer wins command to configure the PPP
peer system as the one that takes precedence. The ppp peer command has no effect
unless both systems have the address configured and the address is in conflict. If the
PPP peer system has the address and the router does not, the peer always supplies
the address regardless of how you have configured the PPP peer.
Example
host1(config-profile)#ppp peer dns
Use the no ppp peer dns command or the no ppp peer wins command when you want
the router to take precedence during setup negotiations between the router and the
remote PC client. If the IP addresses passed to the router by the remote PC client differ
from the ones you have configured on your router, the router returns the values that
you configured as the correct values to the remote PC client.
See ppp peer.
Use to enable reassembly on an MLPPP link interface and optionally specify the
administrative MRRU value, in octets, for the link.
Example
host1(config-profile)#ppp reassembly 1590
Use the no version to disable reassembly on the link and restore the default value,
which is the link's local MRU.
See ppp reassembly.
Use to add an access concentrator (AC) name to the profile configuration.
Example
host1(config-profile)#pppoe acName CYM9876
Use the no version to remove the AC name.
See pppoe acName.
Use to set up the router to offer to set up a session for the client, even if the router has
insufficient resources to establish a session.
This feature is disabled by default.
Example
host1(config-profile)#pppoe always-offer
Chapter 17: Configuring Dynamic Interfaces
583