Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 724

JunosE 11.2.x Link Layer Configuration Guide
show columns
692
Type—Type of circuit: PVC
Encap—Encapsulation method: AUTO, AAL5, MUX, SNAP, ILMI, F4-OAM
Category—Service type configured on the VC: UBR, UBR-PCR, NRT-VBR, RT-VBR,
or CBR
Rx/Tx Peak—Peak rate, in Kbps
Rx/Tx Avg—Average rate, in Kbps
Rx/Tx Burst—Maximum number of cells that can be burst at the peak cell rate
Status—State of the virtual circuit: Up or Down
Start VPI—Starting virtual path identifier (inclusive) of the reserved VC range
Start VCI—Starting virtual circuit identifier (inclusive) of the reserved VC range
End VPI—Ending virtual path identifier (inclusive) of the reserved VC range
End VCI—Ending virtual circuit identifier (inclusive) of the reserved VC range
Example 1—Displays all VCs and reserved VC ranges on the router
host1#show atm vc
Interface VPI VCI
------------ --- ---- ---- ---- ----- ---- ----- ----- ----- ---
ATM 3/0.2 0 101
ATM 3/0.3 0 102
...
ATM 3/0.8099 1 8099 8099 PVC
ATM 3/0.8100 1 8100 8100 PVC
8000 circuit(s) found
Reserved VCC ranges:
Start Start End End
Interface VPI VCI
--------- ----- ----- --- ---
ATM 2/0 2 100
ATM 2/0 3 300
2 reservation(s) found
Example 2—Displays all reserved VC ranges on the router
host1#show atm vc reserved
Reserved VCC ranges:
Start Start End End
Interface VPI VCI
--------- ----- ----- --- ---
ATM 2/0 2 100
ATM 2/0 3 300
2 reservation(s) found
See show atm vc.
Cate Rx/Tx Rx/Tx Rx/Tx Sta
VCD Type Encap gory Peak
4375 PVC AUTO CBR 1000
4376 PVC AUTO CBR 1000
SNAP UBR
SNAP UBR
VPI VCI
2 102
3 303
VPI VCI
2 102
3 303
Copyright © 2010, Juniper Networks, Inc.
Avg Burst tus
0 0 UP
0 0 DOWN
0 0 0 UP
0 0 0 DOWN