Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 125

Copyright © 2010, Juniper Networks, Inc.
Wait DeActivate—Waiting for interface to come up before the software sends the
deactivation request
Wait DeActivation Confirmation—Waiting for deactivation confirmation from the
peer
InOamF5Cells—Number of F5 OAM cells received on this circuit
InOamCellDiscards—Number of received OAM cells that were dropped; dropped
cells include unsupported and invalid F5 cells. The InOamCellDiscards counter is
not incremented after an OAM flush is performed with the atm oam flush command.
For more information about the InOamCellDiscards counter, see "Rate Limiting for
F5 OAM Cells" on page 19.
InF5EndLoopCells—Total number of F5 end-to-end loopback cells received on this
circuit, which is the sum of the following counts:
InF5EndLoopCommands—Number of F5 end-to-end loopback commands received
InF5EndLoopResponses—Number of F5 end-to-end loopback responses received
InF5SegLoopCells—Total number of F5 segment loopback cells received on this
circuit, which is the sum of the following counts:
InF5SegLoopCommands—Number of F5 segment loopback commands received
InF5SegLoopResponses—Number of F5 segment loopback responses received
InF5EndAisCells—Number of F5 end-to-end AIS cells received on this circuit
InF5SegAisCells—Number of F5 segment AIS cells received on this circuit
InF5EndRdiCells—Number of F5 end-to-end RDI cells received on this circuit
InF5SegRdiCells—Number of F5 segment RDI cells received on this circuit
InF5EndCCActDeActCells—Number of F5 end-to-end activation and deactivation
CC cells received on this circuit
InF5SegCCActDeActCells—Number of F5 segment activation and deactivation CC
cells received on this circuit
InF5EndCCCells—Number of F5 end-to-end CC cells received on this circuit
InF5SegCCCells—Number of F5 segment CC cells received on this circuit
OutOamF5Cells—Number of F5 OAM cells transmitted on this circuit
OutF5EndLoopCells—Total number of F5 end-to-end loopback cells transmitted
on this circuit, which is the sum of the following counts:
OutF5EndLoopCommands—Number of F5 end-to-end loopback commands
transmitted
Chapter 1: Configuring ATM
93