Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 574

JunosE 11.2.x Link Layer Configuration Guide
interface fastEthernet
interface gigabitEthernet
interface tenGigabitEthernet
ip address
542
Use to select an ATM interface or ATM 1483 subinterface.
For information about specifying the ATM interface or subinterface, see "interface atm"
on page 529.
Examples
host1(config)#interface atm 5/0.1
host1(config)#interface atm 4/0/2.1
Use the no version to remove the interface or subinterface.
See interface atm.
Use to select a Fast Ethernet interface.
Example
host1(config)#interface fastEthernet 4/1
Use the no version to remove IP from an interface or a subinterface. You must issue
the no version from the highest level down; you cannot remove an interface or a
subinterface if the one above it still exists.
See interface fastEthernet.
Use to select a Gigabit Ethernet interface or a 10-Gigabit Ethernet interface.
To specify a Gigabit Ethernet interface for ERX7xx models, ERX14xx models, and ERX310
router, use the slot/port[.subinterface ] format.
To specify a Gigabit Ethernet interface or a 10-Gigabit Ethernet interface for E120 and
E320 routers, use the slot/adapter/port[.subinterface ] format.
For more information, see chapter Configuring Ethernet Interfaces in JunosE Physical
Layer Configuration Guide.
Examples
host1(config)#interface gigabitEthernet 1/0
host1(config)#interface gigabitEthernet 4/0/1
host1(config)#interface tenGigabitEthernet 4/0/1
Use the no version to remove IP from an interface. You must issue the no version from
the highest level down; you cannot remove an interface or subinterface if the one above
it still exists.
See interface gigabitEthernet.
See interface tenGigabitEthernet.
Copyright © 2010, Juniper Networks, Inc.