Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 449

pppoe remote-circuit-id
radius override calling-station-id remote-circuit-id
Copyright © 2010, Juniper Networks, Inc.
Calling Number Format
agent-circuit-id include-agent-remote-id
agent-remote-id
descriptive include-agent-circuit-id
descriptive include-agent-circuit-id
include-agent-remote-id
descriptive include-agent-remote-id
You can specify either descriptive format or fixed format.
Example
host1(config)#aaa tunnel calling-number-format-fallback fixed
Use the no version to restore the default format, descriptive.
See aaa tunnel calling-number-format-fallback.
Use to enable a static PPPoE interface (from Interface Configuration mode or
Subinterface Configuration mode) or a dynamic PPPoE interface (from Profile
Configuration mode) to capture and process a vendor-specific tag containing a remote
circuit ID transmitted from a DSLAM.
The router can then send this value to a RADIUS server or to an L2TP network server
(LNS) to uniquely identify subscriber locations.
Examples
host1(config-if)#pppoe remote-circuit-id
host1(config-profile)#pppoe remote-circuit-id
Use the no version to restore the default behavior, which is not to capture and process
the PPPoE remote circuit ID.
See pppoe remote-circuit-id.
Use to configure RADIUS to override the standard use of the Calling-Station-Id [31]
RADIUS attribute and instead use the PPPoE remote circuit ID transmitted from a
DSLAM.
Example
host1(config)#radius override calling-station-id remote-circuit-id
Use the no version to restore the default Calling-Station-Id value, which is the telephone
number from which the call originated.
See radius override calling-station-id remote-circuit-id.
Chapter 12: Configuring Point-to-Point Protocol over Ethernet
Fallback Trigger
Both agent-circuit-id and agent-remote-id
are empty.
agent-remote-id is empty
agent-circuit-id is empty
Both agent-circuit-id and agent-remote-id
are empty.
agent-remote-id is empty
417