Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 317

Copyright © 2010, Juniper Networks, Inc.
IPV6CP protocol configuration
configured—IPv6CP is configured on this interface (true or false)
administrative-status—IPv6CP administrative status (open or closed)
ipv6-interfaceId—Address to be used for negotiation of local IPv6 address option
IPCP protocol status
operational-status—IPCP operational status (up, down, not present, or not present
no resources)
terminate-reason—Reason for termination of IPCP service
IPV6CP protocol status
operational-status—IPv6CP operational status (up, down, not present, or not
present no resources)
terminate-reason—Reason for termination of IPv6CP service
IPCP negotiated options—Shows the following negotiated addresses for the local
and remote (peer) side of the link
ip-address—IP address
ip-address-mask—IP address mask
primary-dns-address—Primary DNS address
secondary-dns-address—Secondary DNS address
primary-wins-address—Primary WINS address
secondary-wins-address—Secondary WINS address
NOTE: The command displays a value of "none" for any negotiated option parameters
if the option was not negotiated.
OSINLCP protocol configuration
configured—OSINLCP is configured on this interface (true or false)
administrative-status—OSINLCP administrative status (open or closed)
OSINLCP protocol status
operational-status—OSINLCP operational status (up, down, not present, or not
present no resources)
terminate-reason—Reason for termination of OSINLCP service
OSINLCP negotiated options
Chapter 8: Configuring Point-to-Point Protocol
285