Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 114

JunosE 11.2.x Link Layer Configuration Guide
82
TimeOut—Timeout configured on the interface
SentCellCount—Number of loopback cells sent
RespCount—Number of loopback response cells received
Status—Status of the ping
Ping Cell Count—Cell count configured on the circuit
Ping Time Out—Timeout, in seconds, configured on the circuit
No Of Cells Sent—Number of ping cells sent on this circuit
No Of Response Received—Number of ping responses received on this circuit
Success Rate—Percentage of successful responses received for pings sent
round-trip min/max/avg—Minimum, maximum, and average time in milliseconds
that it took to receive responses to ping messages sent
Ping Status—Results of the ping operation
Ping Completed—Number of ping requests in the cell count were sent
Ping in Progress—Ping is in operation
Ping Not Started—Ping operation is not started; you may see this via SNMP
Ping Stopped—Ping operation was manually stopped
Ping Stopped OAM Down—atm oam flush command was issued when ping was
enabled
ATM Interface Down—Ping operation is stopped as a result of interface down
operational status
OAM Flow Type—Segment, End-to-end
Example 1—Displays all entries in the router
host1#show atm ping
Interface VPI VCI CellCount TimeOut SentCellCount RespCount
--------- --- --- --------- -------
ATM 2/1 0 100
ATM 2/1 0 200
ATM 2/2 0 100
ATM 2/2 0 200
% Found 4 Entries in the system
Example 2—Displays entries on an interface
host1#show atm ping 2/1
Interface VPI VCI
--------- --- ---
ATM 2/1 0 100
ATM 2/1 0 200
% Found 2 Entries in this Interface
------------- --------- -------
5 5 5
5 5 5
5 5 5
5 5 5
CellCount TimeOut SentCellCount RespCount
--------- ------- ------------- ---------- -------
5 5
5 5
Copyright © 2010, Juniper Networks, Inc.
Status
5 Ping Completed
5 Ping Completed
5 Ping Completed
5 Ping Completed
Status
5 5 Ping Completed
5 5 Ping Completed