Assigning An Overriding Profile To An Atm Pvc - Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual

JunosE 11.2.x Link Layer Configuration Guide
642
The following sections describe how to perform these tasks.

Assigning an Overriding Profile to an ATM PVC

You can assign an overriding profile to a single ATM PVC within a bulk-configured VC
subrange. Typically, the overriding profile includes debugging attributes to help you
identify and troubleshoot problems with the ATM 1483 dynamic subinterface column
created on the specified PVC.
To assign an overriding profile to an ATM PVC within a bulk-configured VC subrange:
Configure both of the following:
1.
Base profile for the bulk-configured VC range on the static ATM AAL5 interface.
The VC range consists of one or more VC subranges.
Overriding profile for an ATM PVC within a bulk-configured VC subrange
For information about configuring profiles, see "Configuring a Dynamic Interface from
a Profile" on page 559 in "Configuring Dynamic Interfaces" on page 511.
Create a bulk-configured range of VCs on a static ATM AAL5 interface. The following
2.
commands create a bulk-configured VC range named myBulkConfig that consists
of two VC subranges. The first subrange encompasses VPIs 0–4 and VCIs 21–1000.
The second subrange encompasses VPIs 5–7 and VCIs 21–2000.
host1(config)#interface atm 4/0
host1(config-if)#atm bulk-config myBulkConfig vc-range 0 4 21 1000
vc-range 5 7 21 2000
Assign the previously configured base profile (atm1483BaseProfile) to the
3.
bulk-configured VC range.
host1(config-if)#profile atm1483 bulk-config-name myBulkConfig
atm1483BaseProfile
Assign the previously configured overriding profile to a single ATM PVC within the
4.
bulk-configured VC subrange. The following command assigns the overriding profile
myDebugProfile to the PVC with VPI 0 and VCI 101. This PVC exists within the first
VC subrange (VPIs 0–4 and VCIs 21–1000) configured in Step 2.
host1(config-if)#profile atm1483 bulk-config-name myBulkConfig pvc 0 101
myDebugProfile
The router now uses the information in the overriding profile instead of the information
in the base profile to create subsequent ATM 1483 dynamic subinterface columns
over this PVC.
(Optional) You can assign the same overriding profile to a different ATM PVC within
5.
the same VC subrange or within a different VC subrange. For example, the following
command assigns the overriding profile myDebugProfile to the PVC with VPI 6 and
VCI 901. This PVC exists within the second VC subrange (VPIs 5–7 and VCIs 21–2000)
configured in Step 2.
host1(config-if)#profile atm1483 bulk-config-name myBulkConfig pvc 6 901
myDebugProfile
Copyright © 2010, Juniper Networks, Inc.