Monitoring Bridged Ethernet - Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual

JunosE 11.2.x Link Layer Configuration Guide

Monitoring Bridged Ethernet

show bridge1483 interface
460
Use to set the maximum allowable size, in bytes, of the MTU for bridged Ethernet
interfaces.
Specify an MTU size in the range 64–9180 bytes.
Example
host1(config-subif)#bridge1483 mtu 1684
Use the no version to restore the default MTU size for bridged Ethernet interfaces, 1518
bytes.
See bridge1483 mtu.
You can:
Display information about bridged Ethernet interfaces by using the show bridge1483
interface command.
Monitor MAC address validation by using the show ip mac-validate interface command.
Display information about VLANs configured on bridged Ethernet interfaces by using
the show vlan subinterface command.
Bridged Ethernet interfaces are not bound to a specific virtual router (VR).
NOTE: The E120 and E320 routers output for monitor and show commands is identical
to output from other E Series routers, except that the E120 and E320 routers output
also includes information about the adapter identifier in the interface specifier
(slot/adapter/port).
Use to display configuration and status information for all bridged Ethernet interfaces
currently configured on the router.
Use the atm keyword and an interface specifier to display information for a bridged
Ethernet interface that is stacked over an ATM subinterface.
Use the summary keyword to display only a count of all bridged Ethernet interfaces
configured on the router.
Field descriptions
Interface—Type and specifier of the lower-layer interface on which bridged Ethernet
is configured
Status—Status of the bridged Ethernet interface: up, down, lowerLayerDown,
notPresent
MAC Address—MAC address assigned to the bridged Ethernet interface, if configured
Type—Type of interface: static or dynamic
Copyright © 2010, Juniper Networks, Inc.