Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 435

pppoe motm
pppoe motm
pppoe url
pppoe url
Copyright © 2010, Juniper Networks, Inc.
Use in the context of a PPPoE subinterface to cause the PPPoE application to send
the specified PADM message to the client as it is configured (if connected).
The message is also sent whenever the subinterface transitions from down to up.
The message string is saved in nonvolatile storage (NVS).
Use in Interface Configuration mode.
Example
host1(config-if)#interface fastEthernet 1/0.1.1
host1(config-if)#pppoe motm Router going down at 10:00 p.m.
Use the no version to disable the message.
See pppoe motm.
Use in a profile to cause the PPPoE application to send the string to the new client that
is created when the profile is dynamically attached to an IP interface.
The message string is saved in nonvolatile storage (NVS).
Use in Profile Configuration mode.
Example
host1(config-profile)#pppoe motm Router going down now
Use the no version to disable the message.
See pppoe motm.
Use in the context of a PPPoE subinterface to cause the PPPoE application to send
the specified PADM message to the client as it is configured (if connected).
The message is also sent whenever the subinterface transitions from down to up.
The message string is saved in nonvolatile storage (NVS).
Use in Interface Configuration mode.
Example
host1(config-if)#interface fastEthernet 1/0.1.1
host1(config-if)#pppoe url http://www.relevanturl.com
Use the no version to disable the message.
See pppoe url.
Use in a profile to cause the PPPoE application to send the string to the new client that
is created when the profile is dynamically attached to an IP interface.
The message string is saved in nonvolatile storage (NVS).
Chapter 12: Configuring Point-to-Point Protocol over Ethernet
403