Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 90

JunosE 11.2.x Link Layer Configuration Guide
inarp
oam ais-rdi
oam cc
58
Use the no version to restore the default encapsulation method, aal5snap.
See encapsulation.
Use to enable Inverse ARP on an ATM PVC that resides on an ATM 1483 NBMA
subinterface and uses the default encapsulation method, aal5snap.
For detailed information about how to use this command, see "inarp" on page 52.
You must issue the exit command from ATM VC Class Configuration mode for the
configuration to take effect.
Example
host1(config-vc-class)#inarp 5
host1(config-vc-class)#exit
Use the no version to restore the default behavior, which disables Inverse ARP on the
router.
See inarp.
Use to configure surveillance parameters for AIS and RDI F5 OAM fault management
cells on an ATM data PVC.
For detailed information about how to use this command, see "oam ais-rdi" on page 49.
You must issue the exit command from ATM VC Class Configuration mode for the
configuration to take effect.
Example
host1(config-vc-class)#oam ais-rdi 5 10
host1(config-vc-class)#exit
Use the no version to restore the default values for the alarm down count (1 successive
alarm cell) and alarm clear timeout duration (3 seconds).
See oam ais-rdi.
Use to enable F5 OAM CC verification on an ATM data PVC.
For detailed information about how to use this command, see "oam cc" on page 50.
You must issue the exit command from ATM VC Class Configuration mode for the
configuration to take effect.
Example 1—Enables CC verification with a source endpoint
host1(config-vc-class)#oam cc source
host1(config-vc-class)#exit
Example 2—Opens an F5 OAM CC segment cell flow and enables CC verification with
a sink endpoint
host1(config-vc-class)#oam cc segment sink
Copyright © 2010, Juniper Networks, Inc.