Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 373

show ppp interface summary
Copyright © 2010, Juniper Networks, Inc.
Link interface fragmentation is enabled
Link interface fragment size is (use MTU)
Link interface reassembly is enabled
Link interface administrative MRRU is (use MRU)
Link interface hash-link-selection is disabled
No baseline has been set
...
Authentication status
grant
session-timeout
inactivity-timeout
monitor-ingress-only
accounting-timeout
peer-ip-address
peer-ip-address-mask
peer-primary-dns-address
peer-secondary-dns-address
peer-primary-wins-address
peer-secondary-wins-address
peer-ipv6-interface-id
See show ppp interface.
Use to display a summary of all the multilinked and nonmultilinked PPP interfaces
configured on the router.
Field descriptions
PPP Status—Non-multilinked PPP interfaces
Configuration status—Indicates the configuration state of the PPP interface, IPCP,
IPv6CP , OSINLCP, or MPLS
configured—Interface or protocol is configured
notConfigured—Interface or protocol is not configured
Administrative status—Indicates the administrative state of the PPP interface, IPCP,
IPv6CP , OSINLCP, or MPLS
open—Interface or protocol is administratively enabled
closed—Interface or protocol is administratively disabled
Operational status (Interface)—Indicates the operational state of the PPP interface
up—Interface is operational
down—Interface is not operational because of a problem in the PPP layer
lowerDown—Interface is not operational because a lower layer in the protocol
stack is down
notPresent—Interface is not operational because the hardware is unavailable
passive—Interface is waiting for the peer to send an LCP confReq message
tunnel—Interface is being redirected through a tunnel
Chapter 9: Configuring Multilink PPP
true
31622400 seconds
none
false
none
100.100.100.17
none
none
none
none
none
none
341