Monitoring Transparent Bridging - Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual

Monitoring Transparent Bridging

Copyright © 2010, Juniper Networks, Inc.
Assign a unique VLAN ID to the VLAN subinterface.
5.
host1(config-if)#vlan id 100
Configure a subscriber (client) bridge group interface over the VLAN subinterface.
6.
Assign the interface to the bridge group you created in Step 1.
host1(config-subif)#bridge-group westford02
Exit Subinterface Configuration mode.
7.
host1(config-subif)#exit
(Optional) Configure additional VLAN subinterfaces and bridge group interfaces by
8.
repeating Steps 4 through 6, supplying unique values.
This section describes how to:
Set a statistics baseline for bridge groups and bridge interfaces.
Remove all dynamic MAC address entries or a specific dynamic MAC address entry
from the forwarding table for bridge groups and bridge interfaces.
Use the show commands to monitor bridge groups, bridge group interfaces, and
subscriber policies
NOTE: The E120 and E320 routers output for monitor and show commands is identical
to output from other E Series routers, except that the E120 and E320 routers output
also includes information about the adapter identifier in the interface specifier
(slot/adapter/port).
Chapter 15: Configuring Transparent Bridging
487