Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 116

JunosE 11.2.x Link Layer Configuration Guide
84
lowerLayerDown
notPresent
up
To display the current state of an ATM subinterface created on the PVC with the
specified VPI and VCI values, use the atm slot/port/vpi/vci format (for ERX7xx models,
ERX14xx models, and ERX310 router) or the slot/adapter/port/vpi/vci format (for E120
and E320 routers) to identify the ATM subinterface (Example 5).
NOTE: You can use the atm slot/port/vpi/vci format as an alternative to the
atm slot/port.subinterface format with the specific show interface and show
subinterface commands to monitor all ATM 1483 subinterfaces (except NBMA
interfaces) as well as the upper-layer interfaces configured over an ATM 1483
subinterface. You cannot, however, use the atm slot/port/vpi/vci format to create or
modify an ATM 1483 subinterface.
These guidelines also apply to E120 and E320 routers when you use the
atm slot/adapter/port/vpi/vci format as an alternative to the
atm slot/adapter/port.subinterface format.
For more information, see "Creating a Basic Configuration" on page 20.
Field descriptions
Interface—Interface identifier
ATM-Prot—One of the following ATM protocol types:
RFC-1483—Multiprotocol encapsulation over AAL5
NBMA—Nonbroadcast multiaccess interface
ATM/MPLS—Local ATM passthrough interface
VCD—Virtual circuit descriptor
VPI—Virtual path identifier
VCI—Virtual circuit (or channel) identifier
Circuit Type—Type of circuit: PVC
Encap—Administered encapsulation method based on what was configured with
the atm pvc command
MTU—Maximum transmission unit size for the interface
Status—One of the following ATM 1483 subinterface states:
Copyright © 2010, Juniper Networks, Inc.