Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 667

atm atm1483 advisory-rx-speed
atm atm1483 auto-configure
Copyright © 2010, Juniper Networks, Inc.
NOTE: For information about the maximum number of VCs (sum of the VPI/VCI
addresses within all VC subranges) that you can configure with the atm bulk-config
command per line module and per chassis, see JunosE Release Notes, Appendix A,
System Maximums.
Do not use any reserved VCI values when configuring VCs with the atm bulk-config
command. For information about reserved VCIs, see "Configuring F4 OAM" on page 31
in "Configuring ATM" on page 3.
Assign the base profile configured for the ATM 1483 subinterface to the VC range
8.
configured on the ATM AAL5 interface.
host1(config-if)#profile atm1483 bulk-config-name myBulkConfig
atm1483BaseProfile
Configure the ATM AAL5 interface to support autodetection of the ATM 1483 dynamic
9.
encapsulation type.
host1(config-if)#auto-configure atm1483
Use to set an advisory receive speed for ATM 1483 subinterfaces that are created with
the profile that you are configuring. This setting has no effect on data forwarding. You
can use it to indicate the speed of the client interface. When traffic is tunneled with
L2TP, the advisory receive speed is sent from the LAC to the LNS. See LAC Configuration
Prerequisites for additional information about the advisory receive speed.
The range is 0–2147483647 kbps.
Example
host1(config-profile)#atm atm1483 advisory-rx-speed 2000
Use the no version to restore the default behavior—the RX speed is not sent to the
LNS.
See atm atm1483 advisory-rx-speed.
Use to specify the types of dynamic upper-interface encapsulations that are accepted
or detected by a dynamic ATM 1483 subinterface.
Include this command in the base profile for a dynamic ATM 1483 subinterface.
For the bridged Ethernet, IP, PPP, and PPPoE encapsulation types, you can optionally
specify the lockout time range for the encapsulation type. For more information, see
"Encapsulation Type Lockout" on page 521 .
Examples
host1(config-profile)#atm atm1483 auto-configure ip lockout-time 3600 7200
host1(config-profile)#atm atm1483 auto-configure pppoe
Chapter 18: Configuring Dynamic Interfaces Using Bulk Configuration
635