Configuring Pppoe Over Vlan; Figure 14: Example Of Ip/Vlan/Fast Ethernet Stacking Configuration - Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual

JunosE 11.2.x Link Layer Configuration Guide

Configuring PPPoE over VLAN

172

Figure 14: Example of IP/VLAN/Fast Ethernet Stacking Configuration

Procedure
To configure PPPoE over VLAN over an Ethernet interface:
Specify a Fast Ethernet, Gigabit Ethernet, or 10-Gigabit Ethernet port.
1.
host1(config)#interface fastEthernet 4/1
Specify VLAN as the encapsulation method.
2.
host1(config-if)#encapsulation vlan
The VLAN major interface is added.
Create a VLAN subinterface by adding a subinterface number to the interface
3.
identification command.
host1(config-if)#interface fastEthernet 4/1.1
Do one of the following:
4.
Assign a VLAN ID for the subinterface.
host1(config-if)#vlan id 201
Assign a VLAN ID and the optional unique MAC address for the subinterface.
host1(config-if)#vlan id 201 mac-address 0090.1a01.1234
Specify PPPoE as the encapsulation method on the interface.
5.
host1(config-if)#pppoe
Create a PPPoE subinterface.
6.
host1(config-if)#pppoe subinterface fastEthernet 4/1.1.1
Specify PPP as the encapsulation method on the interface.
7.
Copyright © 2010, Juniper Networks, Inc.