Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 465

show radius override
Copyright © 2010, Juniper Networks, Inc.
Input policy: bobb statistics enabled
Output policy: bobb statistics enabled
PPP Keepalive
PPP Magic Number
PPP Peer DNS Priority
PPP Peer WINS Priority
PPP Authentication
PPP Authentication Router
PPP Negotiate MRU
PPP Packet Log
PPP State Log
PPP Chap Challenge Length
PPP Passive Mode
PPP Multilink
PPP IPCP Netmask Option
PPP AAA Profile
PPP Multilink Fragmentation : disabled
PPP Multilink Fragment Size : (use MTU)
PPP Multilink Reassembly
PPP Multilink Mrru
PPP Initiate IP
PPP Initiate IPv6
PPPoE Max Sessions
PPPoE Always-offer
PPPoE Remote-Circuit-Id
PPPoE Log PPPoeControlPacket: Disabled
PPPoE duplicate-protect
PPPoE ACNAME
PPPoE URL
PPPoE MOTM
PPPoE Service-Name table
See show profile.
Use to display the current override settings configured on the RADIUS client (LNS) for
the NAS-IP-Address [4], NAS-Port-Id [87], Calling-Station-Id [31], and NAS-Identifier
[32] RADIUS attributes.
Field descriptions
nas-ip-addr—Override setting for the NAS-IP-Address attribute
nas-port-id—Override setting for the NAS-Port-Id attribute; value is remote-circuit-id
if configured with radius override nas-port-id remote-circuit-id command
calling-station-id—Override setting for the Calling-Station-Id attribute; value is
remote-circuit-id if configured with radius override calling-station-id
remote-circuit-id command
nas-info—Virtual router that generates the NAS-IP-Address and NAS-Identifier
attributes for AAA broadcast accounting packets; current virtual router or
authentication virtual router
Example
Chapter 12: Configuring Point-to-Point Protocol over Ethernet
: 30
: enabled
: disabled
: disabled
: pap/chap
:
: (use lower layer MRU)
: disabled
: disabled
: 16 - 32
: disabled
: disabled
: disabled
:
: disabled
: (use MRU)
: disabled
: disabled
: 2
: Disabled
: Enabled
: Enabled
: CYM9876
: http://www.urlofinterest.com
: goodmorning
: myServiceTable1
433