Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 442

JunosE 11.2.x Link Layer Configuration Guide
interface fastEthernet
interface gigabitEthernet
interface tenGigabitEthernet
pppoe
pppoe service-name-table
410
Assign the PPPoE service name table to the PPPoE major interface.
3.
host1(config-if)#pppoe service-name-table myServiceTable1
Use to select a Fast Ethernet interface.
Example
host1(config)#interface fastEthernet 4/1
Use the no version to remove IP from an interface or subinterface. You must issue the
no version from the highest level down; you cannot remove an interface or subinterface
if the one above it still exists.
See interface fastEthernet.
Use to select a Gigabit Ethernet interface or a 10-Gigabit Ethernet interface.
For information about specifying the Gigabit Ethernet or 10-Gigabit Ethernet interface
or subinterface, see "interface gigabitEthernet" on page 400 and "interface
tenGigabitEthernet" on page 400 on "interface tenGigabitEthernet" on page 667.
Examples
host1(config)#interface gigabitEthernet 1/0
host1(config)#interface gigabitEthernet 4/0/1 6.0.0FRS
host1(config)#interface tenGigabitEthernet 4/0/1
Use the no version to remove IP from an interface. You must issue the no version from
the highest level down; you cannot remove an interface or subinterface if the one above
it still exists.
See interface gigabitEthernet.
See interface tenGigabitEthernet.
Use to specify PPPoE as the encapsulation method for the interface.
This command creates a PPPoE major interface.
Example
host1(config-if)#pppoe
Use the no version to remove the PPPoE major interface.
See pppoe.
Copyright © 2010, Juniper Networks, Inc.