Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 113

show atm ping
Copyright © 2010, Juniper Networks, Inc.
OutOamF4SegLoopbackCommands
OutOamF4SegLoopbackResponses
OutOamF4SegRdiCells
OutOamF4SegCCActDeActCells
OutOamF4SegCCCells
Time since last status change
Example 3
host1#show atm oam 2/1 0 end-to-end
Sending End To End Loopback Cells Disabled:
End To End OAM CC verification enabled
OAM CC Type : CC Sink End Point
OAM Current CC state: Ready
VP State
VP Oam State
InOamF4EndCells
InOamF4EndCellsDropped
InOamF4EndLoopbackCells
InOamF4EndLoopbackCommands
InOamF4EndLoopbackResponses
InOamF4EndAisCells :0
InOamF4EndRdiCells :0
InOamF4EndCCActDeActCells
InOamF4EndCCCells
OutOamF4EndCells
OutOamF4EndLoopbackCells
OutOamF4EndLoopbackCommands
OutOamF4EndLoopbackResponses
OutOamF4EndRdiCells
OutOamF4EndCCActDeActCells
OutOamF4EndCCCells
Time since last status change
See show atm oam.
Use to show all existing ping entries, both completed and outstanding. Remember that
ping statistics are overwritten when a new ping is issued on the circuit.
You can specify the following options to show ping for entries for a specific interface,
VPI, or VCI.
interfaceSpecifier—Shows ping entries for this interface
vpi—Shows details of the last ping atm command on this VPI
vci—Shows details of the last ping atm command on this VCI
Field descriptions
Interface—Interface number
VPI—Virtual path identifier
VCI—Virtual channel identifier
CellCount—OAM loopback cell count configured on the interface
Chapter 1: Configuring ATM
:0
:0
:0
:0
:0
:00:00:53
:down
:not managed
:0
:0
:0
:0
:0
:0
:0
:0
:0
:0
:0
:0
:0
:0
:00:00:53
81