Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 480

JunosE 11.2.x Link Layer Configuration Guide
atm pvc
448
Create an IP interface over the bridged Ethernet interface as a peer to the PPPoE
4.
interface.
host1(config-subif)#ip address 160.1.0.1 255.255.255.0
(Optional) Set up the router to validate MAC addresses on the IP interface.
5.
host1(config-subif)#ip mac-validate strict
Exit the subinterface context.
6.
host1(config-subif)#exit
Create a PPPoE subinterface over the major interface.
7.
host1(config)#pppoe subinterface atm 9/1.1.1
Configure PPP encapsulation over the PPPoE subinterface, and the IP interface over
8.
the PPP interface.
host1(config-subif)#encapsulation ppp
host1(config-subif)#ip address 160.1.1.1 255.255.255.0
Use to configure a PVC on an ATM interface. Specify one of the following encapsulation
types:
Copyright © 2010, Juniper Networks, Inc.