Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 193

show interfaces tenGigabitEthernet
Copyright © 2010, Juniper Networks, Inc.
Chapter 4: Configuring Upper-Layer Protocols over Static Ethernet Interfaces
Use to display the status of Gigabit Ethernet interfaces, 10-Gigabit Ethernet interfaces,
VLAN subinterfaces, or S-VLAN subinterfaces.
You can specify the following keywords:
delta—Specifies that baselined statistics are to be shown
brief—Displays the operational status of all configured interfaces
Field descriptions
GigabitEthernet or tenGigabitEthernet interfaceSpecifier—Status of the hardware
on this interface
up—Hardware is operational
down—Hardware is not operational
Administrative status—Operational state that you configured for this interface
up—Interface is enabled
down—Interface is disabled
Hardware—Type of MAC device on this interface
Address—MAC address of the processor on this interface
MAU—Type of medium attachment unit (MAU) on the primary and secondary physical
ports:
SFP—1000BASE-LH, 1000BASE-SX, 1000BASE-ZX; for SFPs that are empty,
SFP (Empty) appears in this field; for SFPs that are installed in the OC3-2 GE APS
I/O module and do not have a Juniper Networks part number programmed, SFP
(GE Compliant) appears in this field
XFP—10GBASE-SR (10 Gbps), 10GBASE-LR (10 Gbps), 10GBASE-ER (10 Gbps);
for XFPs that are empty, XFP (Empty) appears in this field
TX Output Power—Transmitted output optical power
RX Input Power—Received input optical power
MTU—Size of the MTU for this interface
Operational—Size of the largest packet processed
Administrative—Setting for MTU size that you specified
Duplex Mode—Duplex option for this interface
Operational—Duplex option currently used
Administrative—Setting for duplex that you specified
Speed—Line speed for this interface
161