Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 626

JunosE 11.2.x Link Layer Configuration Guide
show atm aal5 interface
594
NOTE: The E120 and E320 routers output for monitor and show commands is identical
to output from other E Series routers, except that the E120 and E320 routers output
also includes information about the adapter identifier in the interface specifier
(slot/adapter/port).
Use to display information about a configured ATM AAL5 interface.
Field descriptions
AAL5 Interface operational status—Operational status of the AAL5 interface: up,
down, lowerLayerDown
time since last status change—Time since last reported change to the AAL5 interface
operational status in hh:mm:ss format
SNMP trap link-status—Whether SNMP link status traps are enabled or disabled on
the ATM AAL5 interface
Auto configure ATM 1483 status—Whether the autoconfiguration feature for a
dynamic ATM 1483 subinterface configured over the ATM AAL5 interface is enabled
or disabled
InPackets—Number of packets received on this interface
InBytes—Number of bytes received on this interface
OutPackets—Number of packets transmitted on this interface
OutBytes—Number of bytes transmitted on this interface
InErrors—Number of incoming errors received on this interface
OutErrors—Number of outgoing errors on this interface
InPacketDiscards—Number of incoming packets discarded on this interface
OutDiscards—Number of outgoing packets discarded on this interface
Example
host1#show atm aal5 interface atm 3/0
AAL5 Interface ATM 3/0 operational status:
time since last status change: 00:08:46
SNMP trap link-status: disabled
Auto configure ATM 1483 status: disabled
InPackets:
InBytes:
OutPackets:
OutBytes:
InErrors:
OutErrors:
InPacketDiscards: 0
OutDiscards:
0
0
0
0
0
0
0
lowerLayerDown
Copyright © 2010, Juniper Networks, Inc.