Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 110

JunosE 11.2.x Link Layer Configuration Guide
78
Ready—OAM CC is not enabled
Active—OAM CC cell flow is running
Activation Failed—OAM CC activation failed
Wait Activate—Waiting for interface to come up before the software sends the
activation request
Wait Activation Confirmation—Waiting for activation confirmation from the peer
Wait DeActivate—Waiting for interface to come up before the software sends the
deactivation request
Wait DeActivation Confirmation—Waiting for deactivation confirmation from the
peer
Segment OAM CC verification—Whether segment CC verification is enabled or
disabled
VP State—State of the VP: up, down
VP End To End Oam State
not managed—Circuit is in normal OAM state; no OAM fault conditions
AIS—Circuit is in AIS state
RDI—Circuit is in RDI state
VP Segment Oam State
not managed—Circuit is in normal OAM state; no OAM fault conditions
AIS—Circuit is in AIS state
RDI—Circuit is in RDI state
InOamF4Cells—Number of F4 OAM cells received
InOamF4CellsDropped—Number of incoming F4 OAM cells that were dropped
InOamF4EndLoopbackCells—Total number of F4 end-to-end loopback cells received
on this interface, which is the sum of the following counts:
InOamF4EndLoopbackCommands—Number of F4 end-to-end loopback
commands received
InOamF4EndLoopbackResponses—Number of F4 end-to-end loopback responses
received
InOamF4SegLoopbackCells—Total number of F4 segment loopback cells received
on this interface, which is the sum of the following counts:
InOamF4SegLoopbackCommands—Number of F4 segment loopback commands
received
Copyright © 2010, Juniper Networks, Inc.