Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 619

profile
svlan ethertype
vlan advisory-rx-speed
vlan advisory-tx-speed
Copyright © 2010, Juniper Networks, Inc.
Use thenoversion to disable the command.
See pppoe url.
Use to create a profile.
You specify a profile name with up to 80 alphanumeric characters.
Example
host1(config)#profile foo
Use the no version to remove a profile.
See profile.
Use to assign an Ethertype value for the S-VLAN subinterface in a profile.
Choose one of the following Ethertype values:
8100—Specifies Ethertype value 0x8100, as defined in IEEE Standard 802.1q
88a8—Specifies Ethertype value 0x88a8, as defined in draft IEEE Standard 802.1ad
9100—Specifies Ethertype value 0x9100, which is the default
Use an Ethertype value that matches the Ethertype value set on the customer premises
equipment (CPE) to which your router connects.
Example
host1(config-profile)#svlan ethertype 8100
Use the no version to restore the default value, 9100.
See svlan ethertype.
Use to set an advisory receive speed for VLAN subinterfaces that are created with the
profile you are configuring. For detailed information about how to use this command,
see "vlan advisory-rx-speed" on page 669.
Example
host1(config-profile)#vlan advisory-rx-speed 2000
Use the no version to restore the default behavior—the Rx speed is not sent to the LNS.
See vlan advisory-rx-speed.
Use to set an advisory connect speed for VLAN subinterfaces that are created with the
profile that you are configuring.For detailed information about how to use this command,
see "vlan advisory-tx-speed" on page 669.
Example
Chapter 17: Configuring Dynamic Interfaces
587