Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 481

encapsulation bridge1483
encapsulation ppp
interface atm
Copyright © 2010, Juniper Networks, Inc.
aal5snap—Specifies a logical link control (LLC) encapsulated circuit;
LLC/Subnetwork Access Protocol (LLC/SNAP) header precedes the protocol
datagram.
aal5mux ip—Specifies a VC multiplexed circuit. This option is used for IP only.
Example
host1(config-subif)#atm pvc 1 0 32 aal5snap 0 0 0
Use the no version to remove the specified PVC.
See atm pvc.
Use to configure bridged Ethernet as the encapsulation method on an interface, and
to optionally assign the MAC address to the interface.
Use the mac-address keyword to configure a specific MAC address for the interface.
Otherwise, the system MAC address is used. The same MAC address can be used on
multiple interfaces.
If the MAC address is configured, you must use the same MAC address whenever you
reenter the encapsulation bridge1483 command for the interface.
The MAC address can be configured only when the interface is created. To change a
MAC address, you must remove the interface and create it again.
Example
host1(config-subif)#encapsulation bridge1483 mac-address 0090.1a01.1234
Use the no version, without the MAC address, to remove bridged Ethernet as the
encapsulation method on the interface.
See encapsulation bridge1483.
Use to configure PPP as the encapsulation method for an interface.
Example
host1(config-subif)#encapsulation ppp
Use the no version to remove PPP as the encapsulation method on the interface.
See encapsulation ppp.
Use to configure an ATM interface or subinterface type.
To specify an ATM interface for ERX7xx models, ERX14xx models, and ERX310 router,
use the slot/port.[subinterface ] format.
slot—Number of the chassis slot
port—Port number on the I/O module
Chapter 14: Configuring Bridged Ethernet
449