Optional Configuration Tasks - Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual

JunosE 11.2.x Link Layer Configuration Guide

Optional Configuration Tasks

ppp description
ppp ipcp lockout
ppp ipcp netmask
274
You can perform the following optional PPP configuration tasks:
Add a text description or alias to a PPP interface.
Configure the IPCP netmask option (option 0x90).
Specify the keepalive timeout value.
Disable magic numbers.
Control validation of the LCP peer magic number when the peer has not negotiated
an LCP magic number.
Configure the maximum number of LCP, IPCP, or IPv6CP renegotiation attempts that
the router accepts before terminating a PPP session.
Specify the maximum receive units.
Configure passive mode.
Specify that the peer IP address is optional for an IPCP negotiation.
Configure name server addressing.
Stop or restart a PPP session.
Configure PPP authentication.
Use to assign a text description or alias to a static PPP interface.
Example
host1(config-if)#ppp description pah8999
Use the no version to remove the description.
See ppp description.
Use to terminate invalid IPv4 subscribers and prevent additional IPCP negotiations.
When Internet Protocol version 6 Control Protocol (IPv6CP) is active, this command
enables unused IPv4 addresses, which are allocated for the IPv6 subscribers, to be
available for the IPCP services for an internally defined time interval (10 seconds).
When the time interval elapses, the subscriber must connect again to negotiate IPCP.
Example
host1(config-subif)#ppp ipcp lockout
Use the no version to disable the IPCP lockout option on the interface.
See ppp ipcp lockout.
Copyright © 2010, Juniper Networks, Inc.