Table 24: Pppoe Service Name Table With Entries - Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual

Software for e series broadband services routers link layer configuration guide
Table of Contents

Advertisement

JunosE 11.2.x Link Layer Configuration Guide
pppoe-service-name-table
406
(Optional) From PPPoE Service Name Table Configuration mode, create entries to
2.
populate the PPPoE service name table.
You can configure up to 16 specific service name entries per table, in addition to the
empty and unknown service name tags.
host1(config-pppoe-service-name-table)#service myISPService action drop
host1(config-pppoe-service-name-table)#service myQOSClass1 action terminate
host1(config-pppoe-service-name-table)#service myQOSClass2 action drop
host1(config-pppoe-service-name-table)#service myQOSClass3
host1(config-pppoe-service-name-table)#service empty-service-name action drop
host1(config-pppoe-service-name-table)#service unknown-service-name action
terminate
These commands build the PPPoE service name table shown in Table 24 on page 406.
This table directs the router to send a PADO packet in response to all PADI requests
containing the myQOSClass1, myQOSClass3, empty service name tags, and unknown
service name tag. The router is directed to drop all PADI requests containing the
myISPService or myQOSClass2 or the empty service name tags.

Table 24: PPPoE Service Name Table with Entries

Service Name
Action
myISPService
Drop
myQOSClass1
Terminate
myQOSClass2
Drop
myQOSClass3
Terminate
" "
Drop
unknown-service-name
Terminate
Exit PPPoE Service Name Table Configuration mode.
3.
host1(config-pppoe-service-name-table)#exit
(Optional) Use the appropriate show command to verify the creation of the PPPoE
4.
service name table and entries.
host1(config)#show pppoe-service-name-table name myServiceTable1
(Optional) Repeat Steps 1 through 4 to configure additional PPPoE service name
5.
tables on the router.
Use from Global Configuration mode to create a PPPoE service name table.
You can create a maximum of 16 PPPoE service name tables per E Series router.
Specify a table name of up to 31 alphanumeric characters.
Copyright © 2010, Juniper Networks, Inc.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.2

Table of Contents