Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 598

JunosE 11.2.x Link Layer Configuration Guide
ip access-routes
ip address
ip auto-configure ip-subscriber
ip auto-detect ip-subscriber
566
Example
host1(config-profile)#bridge1483 mtu 1684
Use the no version to restore the default MTU size for bridged Ethernet interfaces, 1518
bytes.
See bridge1483 mtu.
Use to enable an access route in a profile.
Example
host1(config-profile)#ip access-routes
Use the no version to remove the access route.
See ip access-routes.
Use to assign an IP address to a profile.
Example
host1(config-profile)#ip address 192.13.5.61
Use the no version to remove the IP address assignment from the profile.
See ip address.
Use to configure a primary IP interface to enable dynamic creation of subscriber
interfaces.
Use the include-primary keyword to specify that the primary interface is assigned to
the first subscriber.
Use the exclude-primary keyword to specify that the primary interface is not used for
dynamic subscribers. By default, the primary interface is not assigned to a dynamic
subscriber.
Example
host1(config-profile)#ip auto-configure ip-subscriber include-primary
Use the no version to disable creation of dynamic subscriber interfaces associated
with this primary IP interface. Use the no version with the include-primary keyword to
specify that the primary interface is not assigned to a subscriber. Use the no version
with the exclude-primary keyword to specify that the primary interface is assigned to
a subscriber.
See ip auto-configure ip-subscriber.
Copyright © 2010, Juniper Networks, Inc.