Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 216

JunosE 11.2.x Link Layer Configuration Guide
encapsulation vlan
interface fastEthernet
route interface
svlan ethertype
184
host2(config-if)#svlan id 83 any
host2(config-if)#svlan ethertype 88a8
host2(config-if)#route interface tunnel mpls:tunnel2 45
Use to configure VLAN as the encapsulation method for the interface.
Use the no version to disable VLAN on an interface.
See encapsulation vlan.
Use to select a Fast Ethernet interface on a line module.
Example
host1(config)#interface fastEthernet 3/1
Use the no version to remove the interface or subinterface. You must issue the no
version from the highest level down; you cannot remove an interface or subinterface
if the one above it still exists.
See interface fastEthernet.
Use to route layer 2 traffic on a specific tunnel interface.
Use the no version to negate this command.
NOTE: For details on the use of this command, see chapter Configuring Layer 2 Services
over MPLS in JunosE BGP and MPLS Configuration Guide.
See route interface.
Use to assign an Ethertype value for the S-VLAN tunnel interface.
Choose one of the following Ethertype values:
8100—Specifies Ethertype value 0x8100, as defined in IEEE Standard 802.1q
88a8—Specifies Ethertype value 0x88a8, as defined in draft IEEE Standard 802.1ad
9100—Specifies Ethertype value 0x9100, which is the default
Use an Ethertype value that matches the Ethertype value set on the customer premises
equipment (CPE) to which your router connects.
Example
host1(config-if)#svlan ethertype 8100
Copyright © 2010, Juniper Networks, Inc.