Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 171

baseline frame-relay multilinkinterface
show frame-relay interface
Copyright © 2010, Juniper Networks, Inc.
Use the optional delta keyword with Frame Relay show commands to specify that
baselined statistics are to be shown.
Example
host1#baseline frame-relay interface mlframe-relay boston
There is no no version.
See baseline frame-relay interface.
Use to set a statistics baseline for MLFR links.
The router implements the baseline by reading and storing the statistics at the time
the baseline is set and then subtracting this baseline whenever baseline-relative
statistics are retrieved.
When baselining is requested, the time since the last baseline was set is displayed in
hours:minutes:seconds or days/hours format. If a baseline has not been set, the message
" No baseline has been set" is displayed instead.
The regular interface statistics and LIP statistics for interfaces are subject to the same
baseline timestamp. You cannot set separate baselines for these statistics.
Use the optional delta keyword with Frame Relay show commands to specify that
baselined statistics are to be shown.
Example
host1#baseline frame-relay multilinkinterface serial 3/2
There is no no version.
See baseline frame-relay multilinkinterface.
Use to display the information about the Frame Relay layer of the interface.
Use the brief keyword to display the operational status of all configured interfaces.
Use the optional delta keyword to specify that baselined statistics are to be shown.
Field descriptions
Frame relay interface mlframe-relay—Name of the MLFR bundle
Status of the major Frame Relay interface—One of the following states:
Up—Traffic can flow on the interface
Offline—Traffic cannot flow because hardware is unavailable
Down—Traffic cannot flow because of a problem in the interface at the current
protocol layer
Chapter 3: Configuring Multilink Frame Relay
139