Configuring Radius Clients (Nsm Procedure); Uploading A New Radius Client Dictionary - Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING INFRANET CONTROLLER GUIDE REV 01 Manual

Related
Documentation

Configuring RADIUS Clients (NSM Procedure)

Uploading a New RADIUS Client Dictionary

Copyright © 2010, Juniper Networks, Inc.
Chapter 8: Configuring the Infranet Controller RADIUS Server and Layer 2 Access
Configuring RADIUS Clients (NSM Procedure) on page 77
Configuring a New RADIUS Vendor (NSM Procedure) on page 78
Configuring RADIUS Return Attributes Policies (NSM Procedure) on page 80
To enable the Infranet Controller to respond to a network access device, you must
configure a RADIUS client in the Infranet Controller.
Configure RADIUS clients by following these procedures:
Uploading a New RADIUS Client Dictionary on page 77
1.
2. Creating a RADIUS Dictionary Based on an Existing Model on page 78
Configuring a New RADIUS Vendor (NSM Procedure) on page 78
3.
Creating a RADIUS Client on page 79
4.
To upload a new RADIUS client dictionary to the Infranet Controller:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the Infranet Controller device for
2.
which you want to upload the RADIUS client dictionary.
Click the Configuration tab. In the configuration tree, select UAC > Network Access
3.
> RADIUS Dictionary.
Add or modify settings on the RADIUS Dictionary tab as specified in Table 20 on
4.
page 77.
Click one:
5.
OK—Saves the changes.
Cancel—Cancels the modifications.
NOTE:
You can only remove dictionaries that are not associated with a vendor.
You can download any dictionary from the list, including preinstalled
dictionaries. You can modify the downloaded dictionary, and then upload
it as a new make or model.
Table 20: RADIUS Dictionary Configuration Details
Option Function
Name Specifies the RADIUS dictionary name.
Your Action
Enter a name for the RADIUS
dictionary.
77