Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 580

JunosE 11.2.x Link Layer Configuration Guide
548
For information about the working of the dynamic encapsulation type lockout feature
for PPPoE sessions that contain the IWF-Session DSL Forum VSA (26-254) in PADR
packets, see "Encapsulation Type Lockout Based on DSL Forum VSAs for IWF PPPoE
Sessions" on page 523.
NOTE: Issuing the pppoe clear lockout interface command resets the current lockout
condition for the specified PPPoE client, but does not disable dynamic encapsulation
type lockout for that PPPoE client.
To clear the current lockout condition for a PPPoE client:
Display the source MAC address assigned to the PPPoE client by issuing one of the
1.
following show commands:
To display the source MAC address when there is no available PPPoE session in
progress, use the show pppoe interface lockout-time command.
This command displays multiple entries for the same MAC address if multiple IWF
sessions contain the same MAC address. In the following example, more than one
entry for the same PPPoE client MAC address, 0090.1a42.527c, is displayed under
the Client Address column head. This method of display occurs because the MAC
address in the Client Address field denotes the MAC address of the DSLAM device
at which multiplexing functions are performed and not the address of the originating
PPPoE client (access loop) for PPPoE sessions that contain the IWF-Session DSL
Forum VSA (26-154).
host1#show pppoe interface atm 12/1/1.1.1 lockout-time
PPPoE interface atm 12/1/1.1
Lockout Configuration (seconds): Min 90, Max 120
Total clients in active lockout: 1
Total clients in lockout grace period: 0
Client Address Current Elapsed Next
-------------- ------- ------- ----
0090.1a42.527c
0090.1a42.527c
To display the source MAC address when a subscriber is connected to the router
through an available PPPoE session, use either the show pppoe interface
lockout-time command or the show pppoe subinterface full command. (The
following example shows only the portion of the command display relevant to the
source MAC address.)
host1#show pppoe subinterface full
...
PPPoE subinterface ATM 3/0.101 has source MAC address 0090.1a10.165e
...
For a description of the fields in the command display, see "show pppoe interface
lockout-time" on page 603 and "show pppoe subinterface" on page 604.
Clear the current lockout condition for the PPPoE client associated with the specified
2.
source MAC address on the static PPPoE major interface.
host1#pppoe clear lockout interface atm 3/0.101 0090.1a10.165e
120 30 120
0 0 90
Copyright © 2010, Juniper Networks, Inc.