Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 583

atm pvc
auto-configure
Copyright © 2010, Juniper Networks, Inc.
host1(config-subif)#profile ip foo
(Optional) Assign subscriber identification.
5.
host1(config-subif)#subscriber ip user charlie domain myispname password lucy
Do either of the following:
6.
Configure the subinterface to detect and accept the dynamic IP encapsulation
type using the default lockout time range, 1–300 seconds.
host1(config-subif)#auto-configure ip
Configure the subinterface to detect and accept the dynamic IP encapsulation
type using a nondefault lockout time range. For example, the following command
configures 3600 seconds (1 hour) as the minimum lockout time and 7200 seconds
(2 hours) as the maximum lockout time.
host1(config-subif)#auto-configure ip lockout-time 3600 7200
(Optional) Verify your configuration.
7.
host1#show atm subinterface atm 5/0.1
Use to configure a PVC on an ATM interface. Specify one of the following encapsulation
types:
aal5autoconfig—Enables autodetection of the 1483 encapsulation (LLC/SNAP or
VC multiplexed).
aal5snap—Specifies an LLC encapsulated circuit; LLC/SNAP header precedes the
protocol datagram.
aal5mux ip—Specifies a VC multiplexed circuit. This option is used for IP only.
Example
host1(config-subif)#atm pvc 6 0 11 aal5autoconfig
Use the no version to remove the specified PVC.
See atm pvc.
Use to configure an ATM subinterface to support a dynamic interface. Specifies the
types of dynamic encapsulation that the ATM 1483 subinterface detects and accepts.
For detailed information about how to use this command, see "auto-configure" on
page 528.
Example 1—Enables autodetection for the IP encapsulation type using the default
lockout time range, 1–300 seconds
host1(config-subif)#auto-configure ip
Example 2—Enables autodetection for the IP encapsulation type using a nondefault
lockout time range, 3600–21600 seconds (1–6 hours)
Chapter 17: Configuring Dynamic Interfaces
551