Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 130

JunosE 11.2.x Link Layer Configuration Guide
98
Use to display detailed statistics for a specific ATM VP configured on the router.
Field descriptions
ServiceCategory—Service type on the VP tunnel, if configured: UBR, UBR-PCR,
VBR-NRT, VBR-RT, or CBR
Peak Cell Rate—Peak cell rate in kilobits per second, if a VP tunnel is configured
Maximum VCI per VPI—Maximum number of virtual circuits on each virtual path
Current VCs—Number of VCs currently configured on the router
InPackets—Number of packets received
InBytes—Number of bytes received
InCells—Number of ATM cells received
OutPackets—Number of packets transmitted
OutBytes—Number of bytes transmitted
OutCells—Number of ATM cells transmitted
InErrors—Number of packets with errors received
OutErrors—Number of packets not transmitted on this VP due to errors
InPacketDiscards—Number of incoming packets discarded
InPacketUnknownProtocol—Number of incoming packets with an unknown protocol
type
InByteDiscards—Number of incoming bytes discarded
CrcErrors—Number of CRC errors detected
SAR time-outs—Number of segmentation and reassembly (SAR) timeouts reached
Over-sized SDUs—Number of oversized service data units (SDUs) received
The following fields appear only if F4 OAM is enabled on the VP:
Sending End to End Loopback Cells—Enabled, Disabled
End to End OAM CC verification—Enabled, Disabled
VP State—State of the VP: up, down
VP Oam State—OAM state of the VP: not managed (normal OAM state with no
OAM fault conditions), AIS, RDI
InOamF4EndCells—Number of F4 end-to-end cells received
InOamF4EndCellsDropped—Number of incoming F4 end-to-end cells that were
dropped
Copyright © 2010, Juniper Networks, Inc.