Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 727

Software for e series broadband services routers link layer configuration guide
Table of Contents

Advertisement

show pppoe subinterface
show profile
Copyright © 2010, Juniper Networks, Inc.
Example
host1#show pppoe interface atm 12/1/1.1.1 lockout-time
PPPoE interface atm 12/1/1.1
Lockout Configuration (seconds): Min 90, Max 120
Total clients in active lockout: 1
Total clients in lockout grace period: 0
Client Address Current Elapsed Next
-------------- ------- ------- ----
0090.1a42.527c
0090.1a42.527c
See show pppoe interface lockout-time.
Use to display the source MAC address of a PPPoE client when a subscriber is connected
to the router through an available PPPoE session. You can then specify this MAC
address in "pppoe clear lockout interface" on page 549 to clear the lockout condition
for the PPPoE client.
To display configuration, status, and statistics information, including the source MAC
address of the PPPoE client, use the full keyword.
The following field descriptions and example include only the portion of the show
pppoe subinterface command display relevant to the source MAC address for PPPoE
clients. For more information about using this command, see "show pppoe subinterface"
on page 428 in "Configuring Point-to-Point Protocol over Ethernet" on page 371.
Field descriptions
PPPoE subinterface—Specifier for the PPPoE subinterface
source MAC address—MAC address of the PPPoE client associated with the dynamic
PPPoE subinterface column
Example
host1#show pppoe subinterface full
...
PPPoE subinterface ATM 3/0.101 has source MAC address 0090.1a10.165e
...
See show pppoe subinterface.
Use to display information about profiles.
To display information about a specific profile, use the name keyword.
To display a list of profiles configured on the router, use the brief keyword.
Field descriptions
Profile—Name of the profile that is displayed
IP address—IP address and subnet mask of the interface, or none if the interface is
unnumbered
Chapter 18: Configuring Dynamic Interfaces Using Bulk Configuration
120
30
120
0
0
90
695

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.2

Table of Contents