Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 159

show frame-relay subinterface
Copyright © 2010, Juniper Networks, Inc.
host1#show frame-relay pvc
PVC information for frame relay NNI interface 3/2:1/1
DLCI 101 in sub-interface 3/2:1/1.1, status is active
Number of circuit status inactive transitions is 0
Time since creation 03:27:29, last status change 01:21:29
In pkts: 0
In bytes: 0
In FECN pkts: 0
In BECN pkts: 0
In DE pkts: 0
Dropped pkts: 0
DLCI 102 in sub-interface 3/2:1/1.2, status is active
Number of circuit status inactive transitions is 0
Time since creation 03:27:28, last status change 01:21:29
In pkts: 0
In bytes: 0
In FECN pkts: 0
In BECN pkts: 0
In DE pkts: 0
Dropped pkts: 0
DLCI 103 in sub-interface 3/2:1/1.3, status is active
Number of circuit status inactive transitions is 0
Time since creation 03:27:28, last status change 01:21:29
In pkts: 0
In bytes: 0
In FECN pkts: 0
In BECN pkts: 0
In DE pkts: 0
Dropped pkts: 0
See show frame-relay pvc.
Use to display the state of the Frame Relay subinterface.
The subinterface can be in one of the following states:
Up—Traffic can flow on the interface
Offline—Traffic cannot flow because hardware is unavailable
Down—Traffic cannot flow because of a problem in the interface at the current
protocol layer
LowerLayerDown—Traffic cannot flow because of a problem in an interface at a
lower protocol layer
AdministrativelyDown—Traffic cannot flow because of manual administrative
intervention
Use the optional delta keyword to specify that baselined statistics are to be shown.
The brief keyword displays only the operational status of all configured subinterfaces.
Field descriptions
Chapter 2: Configuring Frame Relay
Out pkts: 0
Out bytes: 0
Out FECN pkts: 0
Out BECN pkts: 0
Out DE pkts: 0
Out pkts: 0
Out bytes: 0
Out FECN pkts: 0
Out BECN pkts: 0
Out DE pkts: 0
Out pkts: 0
Out bytes: 0
Out FECN pkts: 0
Out BECN pkts: 0
Out DE pkts: 0
127