Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 122

JunosE 11.2.x Link Layer Configuration Guide
show atm vc atm
90
host1#show atm vc vpi 0
Interface VPI VCI
------------ --- ---- ---- ---- ----- ---- ----- ----- ----- ---
ATM 3/0.2 0 101
ATM 3/0.3 0 102
2 circuit(s) found that match filter criteria
Example 3—Displays VCs with a VPI of 1 (one) that are assigned the service category
UBR
host1#show atm vc vpi 1 category ubr
Interface VPI VCI
------------ --- ---- ---- ---- ----- ---- ----- ----- ----- ---
ATM 3/0.8099 1 8099 8099 PVC
ATM 3/0.8100 1 8100 8100 PVC
2 circuit(s) found that match filter criteria
Example 4—Displays VCs with a VPI of 0 (zero) and a service category of CBR that
have a status of up
host1#show atm vc vpi 0 category cbr status up
Interface VPI VCI
------------ --- ---- ---- ---- ----- ---- ----- ----- ----- ---
ATM 3/0.2 0 101
1 circuit(s) found that match the filter criteria
Example 5—Displays all reserved VC ranges on the router
host1#show atm vc reserved
Reserved VCC ranges:
Start Start End End
Interface VPI VCI
--------- ----- ----- --- ---
ATM 2/0 2 100
ATM 2/0 3 300
2 reservation(s) found
See show atm vc.
Use to display information about a specific VC.
To specify the circuit to display, do one of the following:
Enter the VCD.
Use the vpi-vci keyword and enter the VPI and VCI.
Enter the description configured for the ATM 1483 subinterface (with the atm
atm1483 description command) on which the VC resides.
Field descriptions
VCD—Virtual circuit descriptor
VPI—Virtual path identifier
Cate Rx/Tx Rx/Tx Rx/Tx Sta
VCD Type Encap gory Peak
4375 PVC AUTO CBR 1000
4376 PVC AUTO CBR 1000
Cate Rx/Tx Rx/Tx Rx/Tx Sta
VCD Type Encap gory Peak
SNAP UBR
SNAP UBR
Cate Rx/Tx Rx/Tx Rx/Tx Sta
VCD Type Encap gory Peak
4375 PVC AUTO CBR 1000
VPI VCI
2 102
3 303
Copyright © 2010, Juniper Networks, Inc.
Avg Burst tus
0 0 UP
0 0 DOWN
Avg Burst tus
0 0 0 UP
0 0 0 DOWN
Avg Burst tus
0 0 UP