Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 364

JunosE 11.2.x Link Layer Configuration Guide
show ppp interface mlppp
332
packets
octets
errors
discards
2 mlppp interfaces found
Use to display information about MLPPP interfaces.
You can display a great variety of information with this complex command. See the
show ppp interface command in "Configuring Point-to-Point Protocol" on page 259,
for more detailed information about the display options.
Use the show ppp interface command to display information about all PPP interfaces,
including MLPPP interfaces.
Field descriptions
PPP interface mlppp—Name and administrative status (up or down) for an MLPPP
bundle
PPP multilink member-interface—Interface type, interface specifier, and
administrative status (up or down) for an MLPPP member link
Network interface administrative status—Indicates whether the interface for the
MLPPP bundle is administratively enabled (open), meaning that the no ppp
shutdown command is operational, or administratively disabled (closed), meaning
that the ppp shutdown command is operational
Link interface administrative status—Indicates whether the interface for the member
link is administratively enabled (open), meaning that the no ppp shutdown command
is operational, or administratively disabled (closed), meaning that the ppp shutdown
command is operational
Configured network protocol—Network protocol configured on the interface
Fragmentation and reassembly configuration:
Link interface fragmentation—Indicates whether MLPPP fragmentation is enabled
or disabled on the link interface
Link interface fragment size—MLPPP fragment size, in octets, currently in use on
the link interface
Link interface reassembly—Indicates whether MLPPP reassembly is enabled or
disabled on the link interface
Link interface administrative MRRU—Administrative MRRU value, in octets, currently
in use on the link interface
Baseline status—Indicates whether a statistics baseline has been set
Interface statistics:
packets—Number of packets received (in) and sent (out) on the interface
octets—Number of octets received (in) and sent (out) on the interface
0 0
125 132
0 0
0 0
Copyright © 2010, Juniper Networks, Inc.