Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 126

JunosE 11.2.x Link Layer Configuration Guide
94
OutF5EndLoopResponses—Number of F5 end-to-end loopback responses
transmitted
OutF5SegLoopCells—Total number of F5 segment loopback cells transmitted on
this circuit, which is the sum of the following counts:
OutF5SegLoopCommands—Number of F5 segment loopback commands
transmitted
OutF5SegLoopResponses—Number of F5 segment loopback responses transmitted
OutF5EndRdiCells—Number of F5 end-to-end RDI cells transmitted on this circuit
OutF5SegRdiCells—Number of F5 segment RDI cells transmitted on this circuit
OutF5EndCCActDeActCells—Number of F5 end-to-end activation and deactivation
CC cells transmitted on this circuit
OutF5SegCCActDeActCells—Number of F5 segment activation and deactivation
CC cells transmitted on this circuit
OutF5EndCCCells—Number of F5 end-to-end CC cells transmitted on this circuit
OutF5SegCCCells—Number of F5 segment CC cells transmitted on this circuit
Circuit is Up/Down—Status of the circuit and time since the status of the circuit last
changed
Example 1—Displays statistics for the VC with a VPI of 46 and a VCI of 47
host1#show atm vc atm 2/0 vpi-vci 46 47
ATM 2/0.1.1: VCD: 45, VPI: 46, VCI: 47, Encap: AAL5-AUTO
Service Type: Ubr
Inverse ARP enable:No
Assigned VC class :premium-subscriber-class
InPackets:
InBytes:
InCells:
OutPackets:
OutBytes:
OutCells:
InErrors:
OutErrors:
InPacketDiscards:
InPacketUnknownProtocol: 0
InByteDiscards:
CrcErrors:
SAR time-outs:
Over-sized SDUs:
Alarm drop count:
Alarm clear timeout:3
OAM VC verification: enabled
OAM loopback cell status: sent
OAM VC status: up
OAM loopback frequency: 10 second interval
OAM up retry count: 3, OAM down retry count: 5
OAM loopback retry frequency: 1 second interval
OAM CC verification: disabled
0
0
0
0
0
0
0
0
0
0
0
0
0
1
Copyright © 2010, Juniper Networks, Inc.