Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 766

JunosE 11.2.x Link Layer Configuration Guide
reassigning for troubleshooting..............................614
using to configure dynamic interfaces................559
working with.................................................................560
protocol data units (PDUs)
number that the remote peer can fail to receive
specifying...............................................................239
rate of transmission of
specifying...............................................................239
standard length of
for link-fault management of Ethernet
interfaces...........................................................239
proxy ARP................................................................................437
PVC (permanent virtual circuit)
assigning VC classes......................................................61
ATM interfaces....................................................387, 523
bulk configuration of..................................................627
configuring encapsulation..........................................47
configuring F5 OAM......................................................48
configuring for bridged IP........................................440
configuring individual parameters for....................43
configuring Inverse ARP................................................51
configuring service category......................................46
creating control PVCs..................................................44
creating data PVCs........................................................45
Frame Relay...........................................108, 116, 121, 138
overview...............................................................................3
pvc command
for control PVCs.............................................................44
for data PVCs...................................................................45
R
RADIUS (Remote Authentication Dial-In User
Service)
authentication of dynamic
interfaces..................................................514, 519, 619
configuring dynamic interfaces from....................519
MLPPP Bundle Name VSA........................................313
overriding attributes for PPPoE......................377, 413
using PPPoE remote circuit ID........................377, 413
radius commands
radius override
calling-station-idremote-circuit-id...................413
radius override nas-port-id
remote-circuit-id......................................................413
radius remote-circuit-id-delimiter...............375, 418
radius remote-circuit-id-format...................375, 418
radius remote-circuit-id-format (dsl-forum-1
keyword)............................................................377, 418
ranges, VC. See VC ranges, bulk configuration of
734
ranges, VLAN See VLAN ranges, bulk configuration
of RDI (remote defect indication) cells
RDI (remote defect indication) cells................................14
reassembly
Frame Relay packets....................................................116
MLPPP
configuring dynamic..........................................323
configuring static.................................................321
overview.................................................................320
Multiclass MLPPP..............................................348, 351
reassigning profiles to dynamic interfaces..................614
relearn command.................................................................478
remote circuit ID, capturing for PPPoE
configuring......................................................................413
dsl-forum-1 format and examples................377, 413
formatting..............................................................375, 413
monitoring.......................................................................421
overview..........................................................................375
sending to RADIUS or L2TP.............................377, 413
troubleshooting.............................................................377
using in profiles..................................................560, 584
remote defect indication cells. See RDI cells
remote loopback mode See OAM loopback mode
remote loopback operation
halting
calculation and display of received data
at the prompt...................................................243
calculation and display of transmitted data
at the prompt...................................................243
viewing calculated loopback details...........243
prerequisite for enabling remote peer to loop
back PDUs..................................................................242
starting.............................................................................242
stopping..........................................................................242
remote loopback request
error message
if local entity is not placed in loopback
mode...................................................................242
if remote entity is not configured for
loopback............................................................242
Loopback control OAM PDU and..........................235
placing the interface of remote peer in
loopback.....................................................................235
received from the local entity
by the remote peer.............................................235
remote OAM entity
prerequisite for enabling loopback operation
on...................................................................................242
Copyright © 2010, Juniper Networks, Inc.