Copyright © 2010, Juniper Networks, Inc.
Proceed with profile reassignment? [confirm] yes
Profile anyConfig replaced by profile anyLogConfig for any.
Example 3—Restores the initial (nondebug) profile assignment for the ppp
encapsulation type shown in Example 1. Assuming that PPP packet logging is not
configured in profile pppConfig, this command also disables logging for the interface
host1#profile-reassign atm 2/0.101 ppp pppConfig
WARNING: Execution of this command will cause all dynamic interfaces over
atm 2/0.101 to be torn-down.
Proceed with profile reassignment? [confirm] yes
Profile pppLogConfig replaced by profile pppConfig for ppp.
There is no no version.
See profile-reassign.
Chapter 17: Configuring Dynamic Interfaces
617
Need help?
Do you have a question about the JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 and is the answer not in the manual?
Questions and answers