Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 310

JunosE 11.2.x Link Layer Configuration Guide
ppp peer
ppp peer-ip-address-optional
ppp shutdown
ppp shutdown ip
ppp shutdown ipv6
ppp shutdown mpls
ppp shutdown osi
278
Use to force a static or dynamic PPP interface into passive mode before LCP negotiation
begins, for a period of one second. This delay enables slow clients to start up and
initiate the LCP negotiation.
Example
host1(config-if)#ppp passive-mode
Use the no version to disable passive mode.
See ppp passive-mode.
Use to resolve conflicts when the router and the PPP peer have the primary and
secondary DNS and WINS name server addresses configured with different values.
By default, the DNS and WINS addresses configured on the router take precedence.
Use the dns keyword or the wins keyword to configure which PPP peer address takes
precedence. This command has no effect unless both routers have the address
configured and the address is in conflict. If the PPP peer has the address and the router
does not, the peer always supplies the address regardless of how you have configured
the PPP peer.
Example
host1(config-if)#ppp peer dns
Use the no version when you want the router to take precedence during setup
negotiations between the router and the peer. If the IP addresses that the peer sends
to the router differ from the ones configured on your router, the router returns the values
that you configured as the correct values to the peer.
See ppp peer.
Use to specify that the peer IP address is optional in an IPCP configuration request. By
default this command is disabled.
Example
host1(config)#ppp peer-ip-address-optional
Use the no version to restore the default behavior
See ppp peer-ip-address-optional.
Copyright © 2010, Juniper Networks, Inc.