Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 318

JunosE 11.2.x Link Layer Configuration Guide
286
npdu-alignment—Negotiated NPDU alignment for the local and remote (peer)
side of the link
NOTE: The command displays a value of "none" for any negotiated option parameters
if the option was not negotiated.
MPLSNLCP protocol configuration
configured—MPLSNLCP is configured on this interface (true or false)
administrative-status—MPLSNLCP administrative status (open or closed)
MPLSNLCP protocol status
operational-status—MPLSNLCP operational status (up, down, not present, or not
present no resources)
terminate-reason—Reason for termination of MPLSNLCP service
MPLSNLCP negotiated options
npdu-alignment—Negotiated NPDU alignment for the local and remote (peer)
side of the link
NOTE: The command displays a value of "none" for any negotiated option parameters
if the option was not negotiated.
LCP protocol configuration
max-receive-unit—Controls negotiation of the local MRU option; "use lower layer"
indicates that the MRU of the layer below PPP defines the MRU to be negotiated;
"disabled" indicates that the MRU option is not to be negotiated. A numeric value
indicates the MRU value to be negotiated
authentication—Controls the negotiation of the local authentication option; "none"
indicates do not negotiate; "chap" indicates negotiate chap; "pap" indicates
negotiate pap; "chap/pap" indicates negotiate chap and, if it is rejected, negotiate
pap; "pap/chap" indicates negotiate pap and, if it is rejected, negotiate chap.
magic-number—Controls whether the local magic number is negotiated: enabled
(negotiate), or disabled (do not negotiate)
magic-number-mismatch—Indicates whether the router is configured to ignore
the LCP peer magic number and retain the PPP connection when the peer has not
negotiated an LCP magic number: ignore (ignore the peer magic number mismatch
and retain the PPP connection), or reject (router terminates the PPP connection
if it detects a peer magic number mismatch)
keepalive-timer—Rate of LCP echo requests
Copyright © 2010, Juniper Networks, Inc.