Platform Considerations; Module Requirements; Interface Specifiers - Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual

JunosE 11.2.x Link Layer Configuration Guide

Platform Considerations

Module Requirements

Interface Specifiers

10
You can configure ATM interfaces on the following Juniper Networks E Series Broadband
Services Routers:
E120 router
E320 router
ERX1440 router
ERX1410 router
ERX710 router
ERX705 router
ERX310 router
For information about the modules that support ATM interfaces on ERX14xx models,
ERX7xx models, and the ERX310 router:
See ERX Module Guide, Table 1, Module Combinations for detailed module specifications.
See ERX Module Guide, Appendix A, Module Protocol Support for information about the
modules that support ATM.
For information about the modules that support ATM interfaces on the E120 and E320
routers:
See E120 and E320 Module Guide, Table 1, Modules and IOAs for detailed module
specifications.
See E120 and E320 Module Guide, Appendix A, IOA Protocol Support for information
about the modules that support MLPPP.
The configuration task examples in this chapter use the slot/port[.subinterface ] format
to specify an ATM interface. However, the interface specifier format that you use depends
on the router that you are using.
For ERX7xx models, ERX14xx models, and ERX310 router, use the slot/port[.subinterface
] format. For example, the following command specifies ATM 1483 subinterface 10 on
slot 0, port 1 of an ERX7xx model, ERX14xx model, or ERX310 router.
host1(config)#interface atm 0/1.10
For E120 and E320 routers use the slot/adapter/port[.subinterface ] format, which includes
an identifier for the bay in which the I/O adapter (IOA) resides. In the software, adapter
0 identifies the right IOA bay (E120 router) and the upper IOA bay (E320 router); adapter
1 identifies the left IOA bay (E120 router) and the lower IOA bay (E320 router). For
Copyright © 2010, Juniper Networks, Inc.