Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 104

JunosE 11.2.x Link Layer Configuration Guide
show atm atm1483
show atm interface
show interfaces atm
72
OutPackets—Number of packets transmitted on this interface
OutBytes—Number of bytes transmitted on this interface
InErrors—Number of incoming errors received on this interface
OutErrors—Number of outgoing errors on this interface
InPacketDiscards—Number of incoming packets discarded on this interface
OutDiscards—Number of outgoing packets discarded on this interface
Example
host1#show atm aal5 interface atm 3/0
AAL5 Interface ATM 3/0 operational status:
time since last status change: 00:08:46
SNMP trap link-status: disabled
Auto configure ATM 1483 status: disabled
InPackets: 0
InBytes: 0
OutPackets: 0
OutBytes: 0
InErrors: 0
OutErrors: 0
InPacketDiscards: 0
OutDiscards: 0
See show atm aal5 interface.
Use to display whether or not the router is set up to export ATM 1483 subinterface
descriptions to the line module.
Example
host1#show atm atm1483
ATM1483 IF Descriptions exported
See show atm atm1483.
Use to display configuration and state information and statistics about a specific ATM
interface, or to display a brief description of all ATM interfaces configured in the router.
To specify an ATM interface for ERX7xx models, ERX14xx models, and ERX310 router,
use the slot/port format.
slot—Number of the chassis slot
port—Port number on the I/O module; on the OC3-2 GE APS I/O module, you can
specify ATM interfaces only in ports 0 and 1; port 2 is reserved for a Gigabit Ethernet
interface
lowerLayerDown
Copyright © 2010, Juniper Networks, Inc.