Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 569

ipv6 address
ipv6 nd
ipv6 unnumbered
Copyright © 2010, Juniper Networks, Inc.
Use to add an IPv6 address to an interface or a subinterface.
Example
host1(config)#interface gigabitEthernet 1/0.25
host1(config-if)#ipv6 address 1::1/64
Use the no version to remove an IPv6 address.
See ipv6 address
Use to enable the IPv6 Neighbor Discovery process on an interface.
You can include the following commands in IPv6 profiles to configure Neighbor
Discovery route advertisement characteristics.
Command
ipv6 nd
ipv6 nd other-config-flag
ipv6 nd ra-interval
Example
host1(config)#profile ProfileIpv6South22
host1(config-profile)#ipv6 nd
Use the no version to disable the Neighbor Discovery process for the profile.
See ipv6 nd
Use to set up an unnumbered interface.
An unnumbered interface does not have an IPv6 address assigned to it. Unnumbered
interfaces are often used in point-to-point connections where an IPv6 address is not
required.
This command enables IPv6 processing on an interface without your having to assign
an explicit IPv6 address to the interface.
You supply an interface location that is the type and number of another interface on
which the router has an assigned IPv6 address. This interface cannot be another
unnumbered interface.
Example
host1(config-if)#ipv6 unnumbered loopback 0
Use the no version to disable IPv6 processing on an interface.
See ipv6 unnumbered
Chapter 17: Configuring Dynamic Interfaces
Description
Enables Neighbor Discovery on an interface
Sets the "other stateful configuration" flag in IPv6 router
advertisements
Configures the interval between IPv6 router advertisements
537