Configuration Tasks; Table 28: Prerequisite Tasks For Configuring Transparent Bridging - Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual

JunosE 11.2.x Link Layer Configuration Guide

Configuration Tasks

472
Appendix A, Module Protocol Support or E120 and E320 Module Guide, Appendix A, IOA
Protocol Support for information about the modules that support transparent bridging.
Each configured line can transmit data to and receive data from your switch
connections.
Table 28 on page 472 lists the prerequisite tasks for configuring transparent bridging and
the resources that you can consult to learn how to perform these tasks.

Table 28: Prerequisite Tasks for Configuring Transparent Bridging

To Learn About
Preconfiguration and hardware
diagnostic procedures
Configuring T3 ATM line modules
Configuring OCx/STMx ATM line
modules
Configuring Ethernet line modules
Also have the following information available:
A diagram of your network topology indicating the names of the bridge groups and
bridge group interfaces that you need to create
On ERX7xx models, ERX14xx models, and ERX310 router, the slot and port numbers
of the line modules over which you want to configure transparent bridging
On E120 and E320 routers, slot, adapter, and port numbers of the IOAs over which you
want to configure transparent bridging
Types and specifiers for the interfaces and subinterfaces over which you want to create
bridge group interfaces
To configure transparent bridging on an E Series router:
Create a bridge group.
1.
(Optional) Set optional attributes for the bridge group.
2.
Configure bridge group interfaces.
3.
(Optional) Configure nondefault subscriber policies for bridge interfaces.
4.
(Optional) Enable concurrent routing and bridging.
5.
(Optional) If CRB is enabled, configure explicit routing for IP, MPLS, or PPPoE
6.
protocols.
See
ERX Hardware Guide
E120 and E320 Hardware Guide
Chapter Configuring T3 and E3 Interfaces in JunosE
Physical Layer Configuration Guide
Chapter Configuring Unchannelized OCx/STMx
Interfaces in JunosE Physical Layer Configuration Guide
Chapter Configuring Ethernet Interfaces in JunosE
Physical Layer Configuration Guide
Copyright © 2010, Juniper Networks, Inc.