Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 432

JunosE 11.2.x Link Layer Configuration Guide
interface gigabitEthernet
interface tenGigabitEthernet
ip address
pppoe
400
host1(config)#interface fastEthernet 1/0
Use the no version to remove IP from an interface or subinterface. You must issue the
no version from the highest level down; you cannot remove an interface or subinterface
if the one above it still exists.
See interface fastEthernet.
Use to select a Gigabit Ethernet interface or a 10-Gigabit Ethernet interface.
To specify a Gigabit Ethernet interface for ERX7xx models, ERX14xx models, and ERX310
router, use the slot/port[.subinterface ] format.
To specify a Gigabit Ethernet interface or 10-Gigabit Ethernet interface for E120 and
E320 routers, use the slot/adapter/port[.subinterface ] format.
For more information, see chapter Configuring Ethernet Interfaces in JunosE Physical
Layer Configuration Guide.
Examples
host1(config)#interface gigabitEthernet 1/0
host1(config)#interface gigabitEthernet 4/0/1 6.0.0FRS
host1(config)#interface tenGigabitEthernet 4/0/1
Use the no version to remove IP from an interface. You must issue the no version from
the highest level down; you cannot remove an interface or subinterface if the one above
it still exists.
See interface gigabitEthernet.
See interface tenGigabitEthernet.
Use to assign an IP address and subnet mask to an interface or subinterface.
Example
host1(config-if)#ip address 192.1.1.1 255.255.255.0
Use the no version to remove an IP address or disable IP processing.
See ip address.
Use to specify PPPoE as the encapsulation method for the interface.
This command creates a PPPoE major interface.
Example
host1(config-if)#pppoe
Copyright © 2010, Juniper Networks, Inc.