Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 349

ppp mru
ppp passive-mode
Copyright © 2010, Juniper Networks, Inc.
host1(config-if)#ppp max-negotiations ipcp
Example 3—Sets the maximum number of LCP, IPCP, and IPv6CP renegotiation
attempts to 15
host1(config-if)#ppp max-negotiations 15
Example 4—Restores the maximum number of LCP, IPCP, and IPv6CP renegotiation
attempts to the default value, 30
host1(config-if)#no ppp max-negotiations
Use the no version to restore the default value, 30 renegotiation attempts.
See ppp max-negotiations.
Use to control the negotiation of the maximum receive unit (MRU).
Specify the number of bytes, in the range 64–65535.
We recommend you coordinate this value with the network administrator on the other
end of the line.
If the value configured for the PPP MRU is greater than the value of the lower-layer
MRU minus the PPP header length, the router logs a warning message and uses the
lesser of the configured MRU value or the lower-layer MRU value minus the PPP header
length to negotiate the local MRU.
If the value configured for the PPP MRU conflicts with a similar value configured for
another protocol, such as the MTU value for PPPoE, the router uses the lesser of the
two values.
If you issue the command in the context of an encapsulated MLPPP interface, it affects
only that interface. If you issue the command in the context of an MLPPP bundle, it
affects all member links within that bundle.
Example
host1(config-if)#ppp mru 576
Use the no version to restore the default value, which causes PPP to use the lower-layer
MRU minus the PPP header length as the MRU value.
See ppp mru.
Use to force a static or dynamic PPP interface into passive mode, for a period of one
second, before LCP negotiation begins. This delay enables slow clients to start up and
initiate the LCP negotiation.
Example
host1(config-if)#ppp passive-mode
Use the no version to disable passive mode.
See ppp passive-mode.
Chapter 9: Configuring Multilink PPP
317