JunosE 11.2.x Link Layer Configuration Guide
Figure 18: Example of PPPoE over S-VLAN Stacking Configuration Procedure
encapsulation ppp
encapsulation vlan
ip address
pppoe
180
Use to configure PPP as the encapsulation method for the interface.
Use the no version to remove PPP as the encapsulation method on the interface.
See encapsulation ppp.
Use to configure VLAN as the encapsulation method for the interface.
Use the no version to remove VLAN as the encapsulation method on the interface.
See encapsulation vlan.
Use to set a primary or secondary IP address for an interface or subinterface.
Specify the layer 2 encapsulation before you set the IP address.
Use the no version to remove an IP address or disable IP processing.
See ip address.
Use to configure PPPoE as the encapsulation method on the interface.
Use the no version to disable PPPoE on the interface.
See pppoe.
Copyright © 2010, Juniper Networks, Inc.
Need help?
Do you have a question about the JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 and is the answer not in the manual?
Questions and answers